Mist Eliminator Quality

The mist eliminator quality normally focused on the following 4 sides.

1.The Mist Eliminator Engineering

1) Effective area：As much as possible to use the cut model mist eliminator instead of the closed steel plate along the absorber circle for the roof design mist eliminator.

2) Flushing area: Normally over 150% flushing area is necessary for the mist eliminator reliable operation.

3) The stability of the whole mist eliminator: Low stability design will lead to the mist eliminator module mal-position, also collapse is possible due to the mist eliminator is always in micro-vibration state plus the expansion caused by gas heat and contraction caused by cold flushing water.

2.Material

The main material including the profile, flushing pipe and pipe support material.

1) Profile

Normally by PPTV, which includes about 20% talcum, the profile color should be milk white. A few suppliers, especially the famous global supplier, has changed the color to black or other deep color, which possible including high percent of recycled PP to save the cost. On the other hand, the profile thickness is also very important, normally thicker than 3.0mm for the flat design mist eliminator and thicker than 2.8mm for the roof design mist eliminator.

2) Flushing pipe

Normally by PPH

3) Pipe support

The pipe support, integrated in the scope of supply by mist eliminator supplier for the roof design mist eliminator, will be high relation to the safety of flushing system.

3.The craft for mist eliminator assembly

The assembly quality is reliable for the professional mist eliminator manufacturer.

4.Installation Quality

1) It must be under total instruction by the responsible supervisor dispatched by the mist eliminator supplier.

2) The site welding job must be done by the supervisor if the flushing pipe connected by site welding method. The screw connection proposal is better solution.